Briggs Vertical Pullstart In Depth Repair

Tools/Parts Required Flat Head ScrewdriverSocket Wrench – 7/16 SocketNeedle Nose PliersStarter Handle & Cord Step 1. Remove the plastic cover on the pull start, do this with caution as the spring underneath is wound tightly. Undo the bolt holding the spring in place, again being cautious of the spring. Carefully remove the starter, being careful not […]

Briggs and Stratton Start Cord Replacement

Tools/Parts Required. Socket Wrench – 10mm & 12mm Socket Flat Head Screwdriver Scissors Replacement Starter Cord (Click Here)   Step 1. Undo the bolts holding the top cover in position, the are 4 easily visible, 2 at the front and 2 at the back. There is also another bolt at the bottom right hidden under […]

Briggs and Stratton 375 Sprint Pull Start Repair

Tools/Parts Required Flat Head ScrewdriverCleaning MaterialsReplacement Cord If RequiredSocket Wrench & 10mm or 11mm socket depending on engine. Step 1. Remove the Pull start from your engine and clean it thoroughly, this makes it easier to work on and put back together. Step 2 Carefully bend up the 3 tabs that secure the starter and carefully […]

Briggs and Stratton 3HP Pull start Repair

Tools/Parts: Flat Head Screwdriver Cleaning Materials Replacement Cord if Required 10mm and 13mm socket Step 1 Remove the 13mm Carburetor and Starter Mounting Bolt and also the 10mm bolt then remove the pull start. Step 2 Carefully pry up the cover being mindful of the high tension spring that will be underneath. Step 3 Clean […]

Victa Advanced Pull-Start Repair

Tools/Parts Required. Tin Snips Pliers. Spanner – 24mm Locking Pliers Phillips Head Screwdriver Socket Wrench – 12mm Socket Replacement Starter Cord 3.5mm     Step 1. Turn of the fuel, remove the fuel line along with the top cover and place it aside. Step 2 Remove the starter by undoing the three bolts holding it […]

Briggs and Stratton Advanced Pull-Start Repair

Tools/Parts Required. Flat Head Screwdriver Phillips Head Screwdriver Socket Wrench – 10mm & 8mm.Sockets Needle Nose Pliers WD-40/Lubricant Replacement Starter Cord   Step 1. Remove the top cover. Don’t forget to remove the bracket holding the throttle cable in place. Step 2 Turn the top cover upside down and undo the screw holding the pull-start […]

Briggs & Stratton Pull Start Rewind

Tools/Parts Required Needle Nose PliersReplacement Starter Cord If RequiredSocket Wrench – 8mm & 10mmFlat Head ScrewdriverWD40/Lubricant Step 1. First we remove the cowling around the pull start and undo the three 8mm bolts Step 2 Next, located under the left side of the fuel tank is a 10mm bolt, undo it and be carefull not to […]

Rewind Victa Pull Start Cord

In todays tutorial we will be showing you how to rewind a victa pull start. These pull starts can sometimes become bit loose, or completely unwind once your cable snaps or while you’re changing the handle.

Tools and parts needed:

Phillips head screwdriver
Flat Head screwdriver
Replacement cord if required